Use Of Touch Control Clock Programmer; Setting The Correct Time - Candy FXP649X Notice D'emploi Et D'installation

5.7 USE OF TOUCH CONTROL CLOCK PROGRAMMER

FUNCTION HOW TO ACTIVATE IT
•Push the central button
MINUTE
1 times
•Press the buttons " " " "
MINDER
to set the required time
•Release all the buttons
• Push the central button
2 times
•Press the buttons
-
" " or "
COOKING
to set the lenght of
TIME
cooking required
•Release all buttons
•Set the cooking function
with the oven function
selector
• Push the central button
3 times
•Press the buttons
END OF to set the time at which
you wish the oven to
COOKING
switch off
•Release the buttons
•Set the cooking function
with the oven function
selector
•Child Lock function is
activated by touching Set (+)
for a minimum of 5 seconds.
KEY LOCK
From this moment on all
other function are locked
the display will flash STOP
and preset time intermittently.

5.8 SETTING THE CORRECT TIME

00:00
select
ATTENTION: The oven will only operate providing the clock is set.
HOWTO SWITCH ITOFF
•When the set time as
elapsed an audible alarm
is activated (this alarm will
- +
stop on its own, however it
can be stopped immediately
by pressing the button)
SELECT.
•When the time is elapsed
the oven will switch off
automatically. Should you
+
"
wish to stop cooking earlier
either turn the function
selector to 0, or set time
to 0:00 (SELECT and
- +
" " "
•At the time set, the oven
will switch off. To switch
- +
" " " "
off manually, turn the oven
function selector to
position O.
•Child Lock function is
deactivated by touching
touchpad Set (+) again for a
minimum of 5 seconds. From
and this moment on all functions
are selectable again.
WARNING : the first operation to carry out after the oven has been installed or following the interruption of
power supply (this is recognizable the display pulsating and showing
is achieved as follows
•Push the central button 4 times
- +
" " " "
•Set time with buttons.
•Release all buttons.
WHAT IT DOES
•Sounds an alarm at the
end of the set time.
•During the process, the
display shows the
remaining time.
•It allows to preset the
cooking time required
for the recipe chosen
•To check how long is left
to run press the SELECT
button 2 Times.
•To alter/change the
" buttons) preset time press SELECT
and "
•Enables you to set the
end of cooking time
•To check the preset time
p ush the central button
3 times
•To modify the preset
time press buttons
SELECT + "
11 GB
WHAT IT IS FOR
•Allows to use the oven as
alarm clock (could be
activated either with
operating the oven or with
out operating the oven)
•Push any button to stop
the signal. Push the central
button to return to the clock
function
- +
" " " buttons
•This function is typically used
with "cooking time" function.
For example if the dish has to
be cooked for 45 minutes and
needs to be ready by 12:30,
simply select the required
function, set the cooking time
- +
" " "
to 45 minutes and the end of
cooking time to 12:30.
•At the end of the cooking set
time, the oven will switch off
automatically and an audible
alarm will ring.
•Cooking will start
automatically at 11:45 (12:30
minus 45 mins) and will
continue until the pre-set end-
of-cooking-time, when the
oven will switch itself off
automatically.
WARNING.
If the END of cooking is
selected without setting the
length of cooking time, the
oven will start cooking
immediately and it will stop
at the END of cooking time
set.
12:00
) is setting the correct time. This