Data Output; Printing A Data Record - Sartorius YADAP-RS Mode D'emploi

Data Output

Printing a Data Record

The print command can be transmitted by pressing the PRINT key on the balance/scale or
by software command over the interface (Esc P).
Automatic Data Output
In the "auto print" operating mode, data is output to the interface port without a print
command. You can have data output automatically at defined print intervals, with or
without the stability parameter. The length of a print interval depends on the setting for
"Adapting the filter" (menu item 1 1 x).
If you activate the auto print setting, data will be transmitted immediately the moment
you turn on the balance/scale.
Weights and Calculated Values
The current value on the display is transmitted together with a data ID code.
This code is printed at the beginning of the line, and can have up to 6 characters.
+ 153.0 g
W1 + 567.8 g
W2 + 1.2519 lb
Qnt + 253 pcs
Prc + 88.2 %
Hld + 153.0 g
Application Values
You can print values determined in application programs at the press of a key or have them
printed automatically.
001 + 153.0 g
Sum + 409.8 g
APW + 1.432 g
AIR + 351.8 g
WAT + 271.5 g
+ 4.4 SG
Ref + 100
Current net value
Weight unit 1 (basic unit)
Weight unit 2 (appl. unit)
Calculated piece count
Calculated reference percentage
"Hold" display
Autom.: Totalizing: stored components
Autom.: Sum of all values
Manual: Counting: reference weight for 1 piece
Autom.: Weight of sample in air
Autom.: Weight of sample in water
Autom.: Result: specific weight
Manual: Selected reference quantity
9