Sartorius YADAP-RS Mode D'emploi page 5

Intended Use of YADAP USB Adapter
This USB interface adapter is a solution that
enables direct connection of the balance/scale to a
computer on the USB (universal serial bus) port.
The USB interface is implemented as a virtual serial
interface over RS-232 (virtual COM port). For the
application program running on the computer,
there is no difference whether the serial interface
is installed in the PC or enabled in the form of
a virtual interface. The interface offers the same
capabilities in either case.
The equipment supplied with the USB interface
adapter includes a CD containing the software
drivers you need to set up a virtual interface on
your computer.
System Requirements for the YADAP-USB Adapter
– Computer (PC) running the Windows 98
Windows 98SE ® , Windows ME
®
or Windows XP operating system
– Available USB port (Type A, 4-pin, female)
Configuring the USB Interface
The USB cable terminates in a 4-pin male Type A
USB connector.
1. Switch on the computer and make sure the
USB port is activated and functional.
2. Plug the USB cable into the USB port on the
computer and switch on the balance/scale.
®
Windows detects the USB device and runs the
Wizard for adding/removing hardware.
® ,
® , Windows 2000 ®
5