Asko HiddenHelper Série Mode D'emploi page 21

Instruction
6A. Stacked installation. Attach the enclosed anti-tilt
protection to the washing machine and the dryer. Push
the upper part of the anti-tilt protection into the dryer
until it hooks into place. Screw the lower part into
place with the screws you removed from the washing
machine (A).
If the machines are placed tightly against the wall, the
dryer cable must be routed through the cutout on the
middle section (B).
6B. Stacked installation in case of dryer with metal feet.
Install the anti-tilt device (available from your local
dealer) on the washing machine and the dryer. Use the
screws to attach the upper part of the anti-tilt device to
back of dryer. Attach the lower part into place with the
screws you removed from the washing machine (A).
If the machines are placed tightly against the wall, the
dryer cable must be routed through the cutout in the
middle section (B).
7. Installation on washing machine or tumble dryer. Attach
the enclosed anti-tilt protection as illustrated. Fasten
them into place using the screws you removed from
the washing machine (A).
Note!
Check that the edges of the spacers are lined up carefully with the edges of the washing machine and tumble dryer before
you attach the anti-tilt device in place.
When installing the spacer on machines that have already been stacked together, first remove the anti-tilt device as it is no
longer needed. Then, follow the rest of instructions above.
Picture
Hidden Helpers
21