Pairing The Wireless Door / Window Contact Directly With Brematicpro Devices - brennenstuhl BREMATIC PRO Mode D'emploi

Wireless door / window contact 868.3 MHz
16 mm
If you are using both spacers (3 mm and 5 mm) use 2 x 16 mm
screws.
16 mm
13 mm
If you are using the high spacer (14.5 mm) screw the installation
plate using 2 x 13 mm screws.
Both spacers (3 mm and 5 mm) can also be installed.
Then, affix the spacers using 2 further 16 mm screws.
16 EN
Pairing the wireless door / window contact
directly with BrematicPRO devices
The door/window contact can be paired directly with the BrematicPRO
wireless switch adapter or flush-mounted actuators.
16 mm
Note: Before you begin the pairing process, ensure that the door and
window contact is closed.
16 mm
Optionally, pairing via the pair button is possible.
You can find an overview of which devices can be directly paired at
www.brematic.com/en/service
13 mm
Press and hold the pair button of the wireless switch adapter or
flush-mounted actuator for 3 seconds until the device LED flashes.
Firstly, the electronics unit and magnet unit are closed (see
diagram). Remove the magnet unit from the electronics unit
while the device LED of the wireless switch adapter or flush-
mounted actuator flashes to couple both devices to one another.
Once the devices have been paired successfully the device LED
of the wireless switch adapter or flush-mounted actuator will
light up continuously. This completes the pairing process.