Device Overview; Front; Back; Control Elements - brennenstuhl BREMATIC PRO Mode D'emploi

Wireless door / window contact 868.3 MHz

Device overview

Front

Back

Control elements

Sabotage switch

The sabotage switch is intended to prevent misuse or the removal of
the device by strangers.
The sabotage switch notifies the BrematicPRO Gateway and the device
LED flashes 1 x for 0.5 seconds as soon as the wireless door / window
contact is removed from the installation plate.
The device LED flashes for 1 second when the housing is closed as soon
as the sabotage switch is in the OK position.

Pair button

By pressing the pair button, the device is put into pairing mode to link
the Home Automation Systems BrematicPRO via the BrematicPRO
Gateway.
14 EN

Inserting / replacing the battery

Device LED
Magnet unit
Spacer plates
Electronics unit
Remove the installation plate.
Rotate the battery cover into the OPEN position using a coin,
for example, to open the battery compartment.
Magnet unit
Pair button Remove the drained battery if required.
Sabotage switch
Insert the battery into the battery compartment with correct
polarity. Ensure that the battery contact on the side also fits on
Battery
the side.
compartment
Close the battery cover and secure it by rotating it into the
Installation plate
CLOSE position.
Press the pair button on the device back.
Battery cover
The battery status is fine if the device LED on the device front
briefly flashes 3 x.
The electronics unit is ready for use.
Note: If the battery is drained, the device LED will flash once
every second.

Function

The wireless door / window contact is part of the Brennenstuhl
Home Automation Systems BrematicPRO, controlled via app or the
BrematicPRO PC software.
The wireless door/window contact notifies the BrematicPRO Gateway
when windows and doors in dry indoor areas have been opened and
closed. When linked with the Home Automation Systems BrematicPRO,
you can monitor if windows are open or closed.
You can find out which devices can be paired with the wireless door /
window contact from the BrematicPRO compatibility list at
www.brematic.com/en/service.
For additional information on components, please refer to the instructions
for use of the respective BrematicPRO wireless component.
1 x 3 V battery (CR2450)