Federal Signal Corporation LP6 Série Instructions D'installation page 4

To replace the flash tube, proceed as follows:
1. Disconnect power.
2. Remove the lens cover locking screw (see figure 2).
3. Unscrew the lens and remove from the base.
4. Grasp the flash tube by its connector and pull it out of its socket, using a gentle "rocking"
motion. See figure 2. Install a new flash tube. Ensure that the O-ring seal rests flat on the
base and assemble the lens.
5. Align the locking screw hole in the lens with the hole in the base and install the
locking screw.
6. Test the light for proper operation.
B. Service.
The Federal factory will service your equipment or provide technical assistance with any
problems that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be accompanied
by a Return Material Authorization. This R.M.A. can be obtained from the local Distributor
or Manufacturer's Representative.
At this time a brief explanation of the service requested, or the nature of the malfunction,
should be provided.
Address all communications and shipments to:
FEDERAL SIGNAL CORPORATION
Electrical Products Division
Service Department
2645 Federal Signal Drive
University Park, IL 60466-3195
C. Replacement Parts.
Description
Dome, Amber
Dome, Blue
Dome, Clear
Dome, Green
Dome, Red
Flash Tube Assy.
Gasket, O-ring
Gasket, base
Part Number
K8589037A
K8589037A-01
K8589037A-02
K8589037A-03
K8589037A-04
K149130A
K8589038A
K8589039A
3