Westfalia 314336600001 Notice De Montage page 4

SIARR
10 - 71
PREPARATION
* Strip the lining from the bottom of the boot.
* On either side, locate the ribs of the pre-marked holes (3 on the left and 2 on the right).
* Drill these holes with a diameter of 17.5mm.
ASSEMBLY
* Place the spacers in their respective locations.
* In the boot, put the backplates in place with the corresponding fastenings (see diagram).
* Fasten the coupling under the vehicle.
* Fit the coupling head (location A) with the fastening set U.
FINISHING
* Tighten all the fastenings to the frame shown below.
* Replace the boot lining.
FASTENING KIT
2 HM16x45 screws
U
2 DEC16 washers
2 HM16 nuts
1 HM10x110 screw
1 CS10 washer
W
1 10,5x27 plain washer
1 spacer 17-12 L:66
1HM10 nut
1 HM10x110 screw
1 CS10 washer
X
1 10,5x27 plain washer
1 spacer 17-12 L:78
1 HM10 nut
M16 AC8.8 19,5daNm M12
M16 AC10.9 27,5daNm M10
M12 AC8.8 8,1daNm M10
ASSEMBLY INSTRUCTIONS
4 HM12x25 screws
V
4 CS12 washers
3 HM10x110 screws
3 CS10 washers
Y
3 10,5x27 plain washers
3 spacers 17-12 L:68
3 HM10 nuts
TORQUES :
AC10.9 11,4daNm M8 AC8.8
AC8.8 4,7daNm M8 AC10.9
AC10.9 6,7daNm
Type Type
Approval No.
Towbar for
Opel Vectra e11*94/20*00*0581
Break modèle 97
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
FICHIER : BUREAU\NOTICEDEMONTAGE\SIARR\NDM10\NDM1071-C - FOLIO NDMANG
314336600001
Max. Total Max. Total
Towable Weight
Authori. Weight
2 005 kg 1 500 kg
Max. Verti- Value
cal load D
75 kg 8,42 kN