SIARR
10 - 71
PREPARATION
* Remove the carpet from the boot and locate the 5 holes located under the chassis.
* Inside the boot, drill the 5 pre-marked holes in the floor with a diameter of 17.5mm.
* On the back plate of the boot, drill the 4 pre-marked holes with a diameter of 10mm.
* Place the coupling under the vehicle.
* Remove the bumper and on the right-hand side, make the same cut-out as that
which already exists on the exhaust side.
ASSEMBLY
* Place the spacers in their respective locations.
* In the boot, put the backplates in place with the corresponding fastenings (see diagram).
* Fasten the coupling under the vehicle.
* Fit the coupling head (location A) with the fastening set U.
FINISHING
* Tighten all the fastenings to the frame shown below.
* Replace the boot lining along with the bumper.
Note : In accordance with OPEL instructions : for vehicles fitted with the new tow ring.
Cut this out and re-weld it as far to the front of the vehicle as possible.
FASTENING KIT
2 HM16x45 screws
U
2 DEC16 washers
W
2 HM16 nuts
4 HM12x25 screws
V
4 CS12 washers
4 HM8x25 screws
X
Z
4 CS8 washers
4 HM8 nuts
M16
AC8.8
19,5daNm
M12
M16
AC10.9
27,5daNm
M10
M12
AC8.8
8,1daNm
M10
ASSEMBLY INSTRUCTIONS
3 HM10x100 screws
1 HM10x110 screw
3 CS10 washers
Y
1 CS10 washer
3 10,5x27 plain washers
1 10,5x27 plain washer
3 spacers 17-12 L:68
1 spacer 17-12 L:66
3 HM10 nuts
1HM10 nut
1 HM10x110 screw
1 CS10 washer
1 10,5x27 plain washer
1 spacer 17-12 L:78
1 HM10 nut
TORQUES :
AC10.9 11,4daNm
M8
AC8.8
AC8.8
4,7daNm
M8
AC10.9
AC10.9
6,7daNm
Type
Type
Approval No.
Towbar for
Opel Vectra
e11*94/20*00*2703
Berline modèle 97
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm
If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm
ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
FICHIER : BUREAU\NOTICEDEMONTAGE\SIARR\NDM10\NDM1071-C - FOLIO NDMANG
314336600001
Max. Total
Max. Total
Towable Weight
Authori. Weight
2 005 kg
1 500 kg
Max. Verti-
Value
cal load
D
75 kg
8,42 kN