Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10. Install blower.
Re-install blower removed in Step 1. Secure blower
with 2 screws from parts bag. Plug blower into black
receptacle.
11. Finish ceiling, then install grille.
Plug light into receptacle in housing. Attach grille pan to
housing with (2) grille mounting screws. Install (2) 60W
(Max.) candelabra bulbs (not included). Attach shade
with hardware as shown. Do not overtighten finial nut.
(2) 60W (MAX.)
CANDELABRA
BULBS
(not included)
GRILLE
PAN
MOUNTING
ROD
FELT WASHER
(thick)
SHADE
FELT WASHER
(thin)
GRILLE
BRACKETS
LIGHT PLUG
JAMB NUT
LOCKWASHER
(2) GRILLE
MOUNTING
SCREWS
FLAT WASHER
FINIAL NUT
RETROFIT
5. Remove old fan and
prepare ceiling.
Enlarge ceiling opening (if necessary) to 9¾" parallel to
joist) by 10½" (perpendicular to joist). (Some models
have a cut-out template on side of carton.)
Existing fan housings are typically attached to the
structure:
• with screws, nails, or staples, which must be removed.
• with hangers or rails which are fastened to joists and
must be removed along with housing.
A pry bar may be needed to remove the old housing.
Leave ductwork and wiring in place.
1
9¾-in.
6. Fold mounting ears flat against
housing.
10½-in.
JOIST
2
5
Publicité
Table des Matières
