Bose Professional DesignMax DM10S-SUB Notice D'installation page 6

Installation
Installing the Loudspeaker
WARNING: Failure to follow the steps below could lead to an unsafe mounting condition, which could create a falling hazard.
Note: A 6-millimeter hex key is required for proper installation.
1. Attach the loudspeaker to the bracket by sliding the arms of the bracket into the slots on the loudspeaker, either on the back or side
of the loudspeaker depending on your chosen loudspeaker position (see Installation Options on page 5).
2. Insert one of the included M8 screws into the hole on each side of the loudspeaker.
3. Tighten the screws using the hex key to secure the loudspeaker to the bracket.
4. Insert one rubber cap into the hole on each side of the loudspeaker.
q
Rotating the Logo
You can rotate the Bose logo to align with your loudspeaker orientation. To rotate the
logo, first remove the grille by removing the three screws on each side of the grille.
With one hand, press the button on the back of the grille. Rotate the logo with the other
hand. The logo can be rotated clockwise or counterclockwise.
Once you've rotated the logo to your desired orientation, replace the grille and secure it
into place with the six screws.
Note: Do not pinch the button inward unless you intend to remove the logo.
Safety and Regulatory Compliance
The Bose DesignMax DM10S-SUB loudspeaker has passed testing and complies with the following specifications and uses:
Listed to ANSI/UL 1480A-2016, Speakers for Commercial & Safety Professional Use
General-Purpose Use - UL Category UEAY, File Number S 5591 Control Number 3N89
Suitable for installation using Class 1, Class 2, Class 3 wiring methods in accordance with NFPA 70, National Electrical Code,
2017, Article 640
The DesignMax DM10S-SUB loudspeaker has been designed to the requirements defined in the following European regulatory
specification for combination systems:
Tested to IEC60268-5, 2007
6 • English
PRO.BOSE.COM
DesignMax DM10S-SUB • Installation Guide
w
r