Connection Diagrams - Bose Professional DesignMax DM10S-SUB Notice D'installation

Setup
Wiring the Loudspeaker
Wire Gauge
The DesignMax DM10S-SUB loudspeaker is designed to work with 18 AWG (0.8 mm

Connection Diagrams

Expose six millimeters (1/4 inch) of bare wire to attach to the terminals.
Note: The loudspeaker is not
rated for use with a rigid conduit.
The loudspeaker is suitable
for a flexible conduit or wiring
connection only.
Loudspeaker Settings
CONNECTOR WIRING
Using a Safety Cable
Some regional construction codes require the use of a secondary
method of securing loudspeakers to support structures
to provide additional safety. Choose a mounting position,
method, and hardware consistent with local building codes and
regulations.
A safety cable can be attached to the loudspeaker using the
threaded insert on the back of the enclosure.
The insert is sized for an M8 screw (not included) with a depth of
15 millimeters (0.59 inches).
4 • English
CONNECTOR WIRING
70V/100V
20W
40W
* Factory default
Transformer Tap Setting
Set tap by turning. Use a flat head screwdriver.
) to 14 AWG (2.1 mm ) size wire only.
2 2
CONNECTOR WIRING
70V
40W 80W
80W 150W
100V
** NC: No Connection (do not use)
DesignMax DM10S-SUB • Installation Guide
PRO.BOSE.COM
8Ω
150W*
8Ω
NC**