Weller WHA 2000 Manuel D'utilisation page 21

7. Do not overload your soldering equipment.
Operate the soldering equipment only at the voltage and pressure, respectively pressure
range mentioned.
8. Use the correct soldering equipment.
Do not use to low-capacity soldering equipment for your work. Do not use the soldering
equipment for purposes it is not intended for.
9. Wear suitable working clothes.
Danger of burn by liquid solder. Wear adequate protective clothing to protect yourself against
burns.
10. Protect your eyes.
Wear protective goggles. Observe especially the warning notes of the adhesives' manufacturer,
when adhesives are processed. Protect yourself against tin splashes. Danger of burn by
liquid solder.
11. Use a solder smoke suction device.
If facilities for the operation of a solder smoke suction device are available, please check
yourself that they have been connected and are operated correctly.
12. Do not use the cable for purposes it is not intended for.
Never carry the soldering equipment on its cable. Do not use the cable to pull the plug out of
the wall outlet. Protect the cable against heat, oil, and sharp edges.
13. Secure the workpiece.
Use a clamping device to secure the workpiece. With this device the workpiece is held down
more safely than with the hand, and moreover you have both hands free to operate the
soldering equipment.
14. Avoid unnatural posture.
Arrange your workplace in a correct ergonomic way. Avoid uncomfortable posture when
working. Always use appropriate soldering equipment.
15. Treat your soldering equipment with care.
Keep the soldering equipment clean in order to be able to work better and more safely.
Observe the maintenance instructions and the notes on the change of the soldering tip.
WHA2000_08.01 20
Check all cables and hoses connected in regular intervals. Repairs my be carried out by an
authorised specialist only. Use genuine Weller spare parts only.
16. Remove the plug from the wall outlet before opening the housing.
17. Do not leave any maintenance equipment.
Before switching the equipment on, please check whether all keys and adjustment equipment
have been removed.
18. Avoid unintentional operation.
Please make sure that the switch is set off, when connection the plug to the wall outlet,
respectively when connection the equipment to the mains. Do not carry the soldering
equipment connected up to the mains with the finger on the master switch.
19. Be attentive.
Watch out what you are doing. Be sensible in working. Do not use the soldering equipment,
if you cannot concentrate on your work.
20. Check the soldering equipment for potential damage.
Before using the soldering equipment again, please check the safety devices or slightly
damaged parts for perfect function as required. Please check whether the moveable parts
work perfectly and do not jam or whether parts are damaged. All parts have to be fitted
correctly and have to meet all conditions in order to safeguard perfect operation of the
soldering equipment. Damaged safety devices and parts have to be repaired or replaced in
an expert manner by an authorised specialist workshop unless nothing to the contrary has
been stipulated in the operating instructions.
21. Warning.
Please only use the accessories or optional devices which are mentioned in the list of
accessories in the operating instructions. Use Weller accessories or optional devices on ori-
ginal Weller equipment only. The use of other tools and other accessories may cause injuries.
22. Please have your soldering equipment repaired by an electric expert
only.
This soldering equipment corresponds to the pertinent safety regulations. Repairs my be
carried out by an electric fitter only, using original Weller spare parts only, otherwise the
operator may have an accident.
04.04.2002, 11:14 Uhr
20