Sharpening - Stihl FG 2 Notice D'emploi

5
6
5
Then turn the knurled nut a little
N
further until the side plate presses
against the file and the stop bar (6)
is lifted about 0.1 to 0.2 mm away
from the stop roller (5).
Swing the clamping lever (7) to the
N
right – the saw chain is locked in
position.
FG 2

Sharpening

Sharpening the Master Cutter
6
7
Sharpen the master cutter with 2 to
N
3 firm strokes of the file, from the
inside to the outside of the side
plate.
Check that the stop bar (1) butts
N
against the stop roller (2).
If this is not the case, readjust the
N
stop bar (3) and move the chain up
against it – check the stop position
again.
2
1
3
2
1
Sharpening the Row of Cutters
Use the setting for the master cutter
N
to sharpen all the other cutters in the
row.
Swing the filing frame upwards.
N
Open the clamping lever.
N
Pull the chain along to the next
N
cutter in the row – push cutter
against the stop.
3
Make sure the stop (3) always locates
properly against the back of the cutter
being sharpened.
Close the clamping lever.
N
Swing the filing frame down.
N
Sharpen the cutter.
N
Repeat this procedure until all
N
cutters in one row have been
sharpened.
Sharpening the Second Row of Cutters
After sharpening all the cutters in the
first row, set the filing tool for the second
row of cutters. Follow description under
"Adjustments".
English
19