Daily Maintenance; Monthly Maintenance - Global Industrial 641410 Manuel De L'utilisateur

MACHINE STORAGE
• Store the machine indoor in a dry location
• Always store the machine with the squeegee and pad/
driver raised off the floor
• Always drain the solution and recovery tank fully before
storing, especially when storing in a cold location
MAINTENANCE

Daily Maintenance

• Wipe the whole machine with clean/damp cloth
• Empty the solution tank by opening solution drain plug
location on the bottom
• Drain and rinse out recovery tank with clean water
• Remove the Pad Driver/Brush and Squeegee assembly
and Clean with clean water
Troubleshooting
Problem
No power
Little or no
solution flow
Poor water pickup
17" Electric Auto
Floor Scrubber
Cause
Unit not plugged in.
Open circuit breaker.
Water flow tap closed.
Clogged solution tank filter.
Empty solution tank.
Squeegee clogged.
Squeegee blades worn.
Squeegee not mounted correctly.
Vacuum hoses have a hole or are loose.
Vacuum hose may be clogged.
Drain hose stopper is loose.
Recovery tank is open.
Recovery tank is full.
Float shut off is clogged.
Vacuum motor is loose.

Monthly Maintenance

• Flush out solution tank with clean water.
• Remove the clear cap and the solution tank filter. Clean
the filter with clean water
• Motors should be tested every 250 hours. Turn on/
off both Pad/Brush and Vacuum motor to ensure the
motors are working properly
Squeegee Rubber Blade Replacement
• Remove the squeegee assembly from the unit (refer to
squeegee assembly installation).
• Unlock the spring lock and slide out the blades.
• Replace with new blade and reassemble.
Turn on circuit breaker.
Open water flow tap.
Clean solution tank filter.
Fill the solution tank.
Clean debris from squeegee with damp towel.
Install new squeegee blades.
Confirm that the squeegee assembly is securely fastened
to the machine and not loose fitting.
Check hose connections and make sure they are firm.
Replace hose if damaged.
Check hose for debris and remove any clogs.
Tighten drain plug.
Confirm the clear recovery tank lid is securely in place.
Drain recovery tank.
Remove float shut off from inside recovery tank and
remove any debris.
Tighten vac motor mounting screws. DO NOT over tighten
or damage will occur
5
User's Manual User's Manual User's Manual
Solution
Plug in the unit.