Varan JHS-1100 Manuel D'utilisation page 11

REMOVE CUTTER
To remove the cutter, use the cutter wrench & spanner
• Spanner hold the shaft
• Using the cutter wrench lock the teeth of cutter, then rotate the wrench to loosen the cutter
• The cutter might be the shaft very tight.
• Hold cutter wrench and rotate it as hard as you can
CONNECT TO A VACUUM CLEANER
Working with a vacuum cleaner to extract dust created by the Wall Chaser
Connect vacuum cleaner's hose to dust extraction port of the Wall Chaser
If your vacuum cleaner requires a special connector, contact your vacuum cleaner supplier for the
proper adapter
ADJUST CHASING DEPTH
Adjust height of front rollers to control chasing depth
• Loosen the screw nuts
• Adjust height of rollers to a proper position
• Lock the screw nuts as tight as possible
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg T: 00352/26908036 – F: 00352/26908040
JHS-1100