Varan JHS-1100 Manuel D'utilisation page 10

HOW TO USE
OPERATION
• Mark the wall surface to be slotted
• Hold front handle with left hand and rear handle with right hand
• Make the front rollers touch the wall surface and raise the rear rollers to make sure there is a
narrow gap between surface and cutter
• Start the Wall Chaser and hold it firmly to avoid initial vibrations
• Push the rear handle to make the cutter cut into the wall slowly
• Right arm lean on to the Wall Chaser and push the Wall Chaser move forward
• Move the Wall Chaser across the surface at a constant speed
• Do not force the Wall Chaser
TO START THE WALL CHASER
• Open box, take out Wall Chaser
• Install Cutter
• Connecting the Wall Chaser with a vacuum cleaner
• Put on the safety goggles
• Plug in the Wall Chaser
• Press the anti-lock button with thumb and hold it
• Press the ON/OFF switch, now the Wall Chaser is running
INSTALL CUTTER
Install Cutter step by step as follows:
• Ensure the Wall Chaser is unplugged from mains power
• Place a washer between the shaft and cutter. It will ensure perfect seating on the shaft and make
it easier to remove the cutter after use.
• Screw the cutter to tight
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg T: 00352/26908036 – F: 00352/26908040
JHS-1100