Safety Precautions; Installation Precautions; Cleaning The Device - Urmet 1092/621 Manuel D'utilisation

1.2 WARNINGS
1.2.1 Power
This device is powered in the range from 100 to 240 VAC. Check the power voltage
before connecting.
Use of an URMET Domus power unit with the required specifications is
recommended.
Do not pull the cable to unplug the device.
Important note:
Inverting the polarity may damage the keyboard.
1.2.2

Safety precautions

Keep the device away from rain and humidity to prevent the risk of fire and
electrocution.
Do not introduce solids or liquids inside the device to prevent the risk of fire and
electrocution. If this should accidentally occur, disconnect the device from the mains
and have it inspected by qualified personnel.
Never open the device. In all cases, contact qualified personnel or the service centre
for repairs.
1.2.3

Installation precautions

Arrange the device in a well-ventilated place to prevent overheating.
For the same reason, do not install sources of heat, such as radiators or hot air ducts.
Keep away from direct sunlight. Do not install in areas subject to excessive dust,
mechanical vibrations or shocks.
Consider the working temperature of the unit (from 5°C to 45°C) and humidity range
(from 10% to 90%) before choosing the installation location. High differences in
temperature with respect to the specified working temperature range can damage the
unit. Do not install the unit over another unit which generates heat.
Wait for a while before operating a device immediately after transporting it from a cold
place to a warm place and vice versa. Wait on average for three hours: this will allow
the device to adapt to the new ambient (temperature, humidity, etc.).
Do not arrange this device on an unstable surface, such as a tottering or slanted table.
The device could fall causing injury or mechanical failures.
Do not install the device in a place where it could be exposed to humidity or water. Do
not direct a jet of water onto the device: risk of fire, electrocution or mechanical failure.
Stop using the device if water or other material should penetrate inside: risk of fire and
electrocution. Contact the retailer or authorised installer.
1.2.4

Cleaning the device

Rub delicately with a dry cloth to remove dust and dirt.
Dip the cloth in neutral detergent if dirt cannot be eliminated with a dry cloth alone.
Do not use volatile liquids (such as petrol, alcohol, solvents, etc.) or chemically treated
clothes to clean the device to prevent deformation, deterioration or scratches to the
surface finish.
8
DS1092-158B