Urmet 1092/621 Manuel D'utilisation page 11

The "Auto" function key is NOT USED.
NOT ENABLED key
"Shot" function key. Operates a "Preset".
TYPICAL SEQUENCES FOR SENDING COMMANDS
KEY SEQUENCE
NUMBER KEY (0-9) + CAM
NUMBER KEY (0-9) + PRESET
NUMBER KEY (0-9) + SHOT
95 + SHOT
HOW TO CONFIGURE THE KEYBOARD
Press the "Setup" key for three seconds.
Type the following password: 8888
Confirm by pressing the middle of the joystick.
Select the number associated to the camera you want to store (max 255) and confirm by
pressing the middle of the joystick.
Select the protocol and confirm by pressing the middle of the joystick.
Select the baud rate and confirm by pressing the middle of the joystick.
Once you entered all parameters press "Esc".
Important note
Refer to the dome manual to know how to set the commands.
001 indicates the camera where to send the commands.
4 indicates the set up speed onto the joystick: min 1, max 4.
P: the protocol you use
B: the baud rate you selected
Press the Setup key for more than 3 seconds to select the keyboard menu, and then change the protocol
and the baud rate. Type the "8888" password and press the middle of the joystick to confirm.
DS1092-158B
FUNCTION
OPERATES THE SELECTED DOME
STORES THE PRESET
OPERATES A PRESET
OPERATES A DEVICE MENU
(SEE THE DOME MANUALS)
11