SOLAC TE7800 Mode D'emploi page 31

SPECIAL MESSAGES:
The following messages can appear on the screen:
Error Cause
Er 30 Power on, cuff inflation
(TE7800) rate is too low or main
TE7801 unit does not connect
with the cuff or cuff is too
loose.
Er 2 Weak signal or cuff is too
loose.
Heavy shock during the
measurement
Bad signal, moving or
talking during the meas-
urement
Lo Low battery power,
cannot inflate
How to correct
1. Reconnect the air tube connector with the
main unit (TE7801)
2. Cuff or bladder leakage, if necessary
replace it. (TE7800/TE7801)
3. Confirm the cuff is wrapped up correctly
(ref 4), retake the measurement. (TE7800/
TE7801)
Cuff too loose. Confirm the cuff is wrapped
up correctly and retake the measurement.
Remain still, and retake the measurement
Change the batteries
EN