Features And Controls - Vollrath Mirage Série Manuel D'utilisation

FEATURES AND CONTROLS

Control Panel
F
E
A
A On/Off button.
B Power/Temp button. Functional only on the range. No function
on the warmer.
C Timer button. Starts the timer.
D Control knob. Selects the power level (1-5).
E ºF and ºC LEDs. Functional only on the range. No function on the
warmer.
F Display panel. Displays the power level, or an error code.
G Timer LED. Illuminates when timer function is operating.
®
Mirage Induction Drop-in Warmers Operator's Manual
G
B C D
OPERATION
WARNING
Electrical Shock Hazard
Keep water and other liquids from entering the inside of the
equipment. Liquid inside the equipment could cause an
electrical shock.
CAUTION
Burn Hazard
Do not touch hot food, liquid or heating surfaces while
equipment is heating or operating.
NOTICE: Do not preheat empty cookware. Because of the speed and
efficiency of the induction range, cookware can very
quickly overheat and be damaged.
NOTICE: Do not drop cooking utensils or other objects onto the
cooking surface. The strong, non-porous surface will
break. The warranty does not cover this type of abuse.
NOTICE: Do not leave an empty pan on an operating unit.
NOTICE: Do not heat sealed cans or containers as they may
explode.
Turn on the Induction Warmer
Press and release .
Adjust the Power Level
Rotate the control knob.
• Clockwise increases the power level.
• Counterclockwise decreases the power level.
Keep Food Warm
NOTICE: Monitor food temperature closely for food safety. The
United States Public Health Service recommends
that hot food be held at a minimum of 140 ºF (60 ºC) to help
prevent bacteria growth.
NOTICE: Do not add cold food to rethermalizing or hot food.
Place a maximum of one induction-ready serving vessel containing
cooked food preheated to above 155 ºF (68 ºC) in the center of the
warmer.
The display should remain constant during operation. If the display is
flashing, see the Troubleshooting section in this manual.
Removing the vessel from the warming surface for more than ten
minutes will cause the unit to automatically turn off. Removing the
vessel for less than ten minutes will not interrupt operation.
Use the Timer
1. Press and release . The timer LED will flash.
2. Rotate the control knob to set the time in full minutes (1-180).
3. When the timer cycle is complete, the warmer turn off.
4. To cancel the timer, press .
3