Dip Switch Settings - urmet domus 1092 Manuel Utilisateur

Dip switch settings and distances for connection between Ref.1092/300 and Ref.1092/316
DIP SWITCH
SETTINGS
* For distances close to or higher than 1200 metres, use of an Urmet Domus Ref.1092/302 active
transmitter (instead of Ref.1092/300 passive transmitter) is recommended.
Important note:
•
Table 3 shows the approximate dip switch settings according to distance. This parameter may vary
according to the quantity of wire used for system installation.
•
The distances may vary according to the wire quality also when the latter is made by the same
manufacturer as the devices.
•
The distances shown in the table refer to the use of colour cameras. Higher distances may be
obtained using black and white cameras.
•
Consider that the distances may decrease if the devices are used with DVR apparatuses.
DS1092-020B
(PASSIVE - ACTIVE)
DISTANCE (m)
250 ÷ 350
350 ÷ 450
450 ÷ 550
550 ÷ 630
630 ÷ 690
690 ÷ 750
750 ÷ 810
810 ÷ 870
Table 3: distances with 24 AWG UTP CAT5 cable
DIP SWITCH
SETTINGS
DISTANCE (m)
870 ÷ 950
950 ÷ 1050
1050 ÷ 1150
1150 ÷ 1235
1235 ÷ 1315 *
1315 ÷ 1385 *
1385 ÷ 1460 *
1460 ÷ 1530 *
11