Skil LT4818-00 Guide D'utilisation page 12

Mount the Guard
WARNING
being injured by the blade.
1. Remove the battery pack from the trimmer.
2. Lay the trimmer on the ground or the floor with the trimmer head facing upward.
3. Align the two bolts (supplied) with the two screw holes in the shaft (Fig. 4), and then
tighten them with the supplied wrench (Fig. 5).
Fig. 4
Mount and Adjust the
Front-Assist Handle
1. Remove the battery pack from the trimmer.
2. Loose the wing nut and remove it with the
hex bolt from the front-assist handle
(Fig. 6).
12
Always wear gloves when mounting or replacing the guard . Be careful
of the blade on the guard and wear gloves to protect your hands from
Fig. 5
Fig. 6
Hex Bolt
Front-Assist Handle
Wing Nut