Komet MicroKom M040 Mode D'emploi page 11

Type of error: The keypad shows no results
• The keypad was not pressed correctly  Press the keypad on the ON or R
marking. Tapping the keypads is better than pressing.
Type of error: Liquid (water/coolant) in head
• Battery compartment not properly closed  Remove battery cover, check
cover O-ring.
• Internal mechanical damage  Repair by KOMET
Type of error: Digital display is blank
• The digital display turns off after 30 seconds  Press ON on the keypad
• Battery is empty  Replace with an original KOMET battery: Order No.
75000 12150. The batteries from other suppliers can create malfunctions of
the electronics.
• Battery is mounted wrong  Mount the battery with its positive pole to the
inside (see marking and pictures on page 9)
Type of error: Display shows BA LO
• Wrong battery / battery is empty  Use the original KOMET battery Order
No. 75000 12150
Type of error: Display status shows continuous Err2...3...4...5...6
• The boring head was adjusted beyond the maximum adjustment range of
the electronic  Adjust the boring head in the opposite direction to about
the center of the total adjustment. The size will show again after about 30
seconds.
Type of error: Display status Err2, Err3, Err4, Err5, Err6, Err7, Err8
• Electronic is defective  Repair by KOMET
Type of error: Display status Err4, III E, E III
• Measuring signal within the permissible measuring range (Err4)  Electronic
is defective: Repair by KOMET
• The maximal measuring range has been exceeded in plus direction. The
measuring signal is to low (III E)  The measuring range in plus direction
exceeded.
• There are circumstances where the measuring signal comes again in a
plausible magnitude (Err4)  The measuring range in plus direction far
exceeded
• The maximal measuring range has been exceeded in minus direction. The
measuring signal is to low ( E III)  The measuring range in minus direction
exceeded.
• There are circumsstances where the measuring signal comes again in a
plausible magnitude (Err4)  The measuring range in minus direction far
exceeded.
Type of error: Display status Err9
• Electronic is defective  Remove the battery and mount it again. If the
error remains than send the boring head for repair to KOMET.
EnglIsh
11