Safety Instructions; Symbols Used In These Operating Instructions; General Safety Instructions; Specified Conditions Of Use - Rittal MC 125 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Rittal Wiring duct cutter MC 125
1

Safety instructions

1.1

Symbols used in these operating instructions

The following symbols are used in this documentation:
Warning!
Hazardous situation which may lead to death or serious inju-
ry if the instructions are not followed.
Caution!
Hazardous situation which may lead to (minor) injuries if the
instructions are not followed.
Note:
Identification of situations that can lead to material damage.
This symbol indicates an "action point" and shows that you should perform an
operation or procedure.
1.2

General safety instructions

Always...
– ... ensure the cutting device is stable and firmly mounted.
– ... check that the blade guard works properly and folds up independently.
– ... wear safety goggles, gloves and protective footwear during work.
– ... remove chips and cutting waste from blade guard/device.
– ... follow the instructions in this operating manual.
– ... instruct new operators in the safe use of the cutting device.
– ... keep and use in a dry environment.
Never...
– ... reach into the cutting area.
– ... cut cables or other metal work pieces.
– ... use to cut several work pieces at the same time.
– ... use the cutting device if damaged or missing parts.
– ... work with a dull knife.
– ... use if you have not read and understood these operating instructions com-
pletely.
– ... expose to corrosive substances.
The device must be completely mounted on a firm and tilt-proof base before op-
erating. The mounting parts are not included. Please use suitable and rugged
mounting parts according to the basis.
The spring-loaded blade guard has to fold up promptly after the cutting proce-
dure. If this feature does not work the knife has to be secured or removed imme-
diately to avoid injuries. Before operating the device again the blade guard has
to be repaired or exchanged.
2

Specified conditions of use

The MC 125 is only to be used to cut plastic wiring ducts and covers up to a
width of 125 mm and a wall thickness up to 2.5 mm. It is only suitable for soft,
non-reinforced plastics.
1 Safety instructions
EN
15

Publicité

Table des Matières
loading

Produits Connexes pour Rittal MC 125

Ce manuel est également adapté pour:

As 4050.435

Table des Matières