Electrical Installation; Control Panel - Vetus WC12S2 Instructions D'installation Et Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
4.5 Electrical installation 12 V / 24 V
Check that the voltage given on the type plate on the motor is
the same as the voltage on board.
Use batteries with sufficient power to guarantee that the toilet
will work correctly.
Connect the power supply as shown in the wiring diagram.
Fit a switch and a fuse in the ('+') wire.
Use wires with minimum cross section of 6 mm
mm
2
(for 24 V).
4.6 Electrical installation 120 V / 230 V
Check that the voltage given on the type plate on the motor is
the same as the voltage on board.
Use batteries with sufficient power to guarantee that the toilet
will work correctly.
Connect the power supply as shown in the wiring diagram.
Fit a switch and a fuse in the ('+') wire.
Use wires with minimum cross section of 6 mm
mm
2
(for 24 V).
4.7 Control panel 12 V / 24 V
Fit the build-in flange with packing in the wall. See the drawing
in the section 'Principal dimensions' for the size of the holes.
Feed the cable through the flange to the toilet and connect it
with the cable on the toilet.
Fit the cover provided over the plug connection for protection.
Click the panel into the build-in flange, making sure that the
O-ring is fitted properly.
4.8 Testing and preparing for operation
Open the supply pipe stopcock and outlet pipe stopcock fully
in order to ensure proper flushing. Press the button, release
and check that the cycle operates correctly. Throw a number of
pieces of toilet paper in the toilet bowl and flush again.
Electric marine toilets WCS(2) - WCL(2)
5 Use
• Make sure that the ball valve in the water supply pipe is
open.
12 V / 24 V:
2
(for 12 V) or 4
120 V / 230 V:
2
(for 12 V) or 4
• After using the toilet shut off the ball valve.
If the toilet has not been used for some time it is advisable to
rinse it with clean water a few times before using it.
The following precautions must be taken during periods of frost
(winter) :
• Shut off the water supply to the toilet.
12 V / 24 V:
120 V / 230 V:
• Pour about 2 litres anti-freeze into the toilet pot.
• Drain the pipes.
Anti-freeze is poisonous and must never be drained into the
external water.
• A short or long flush can be used.
• Short flush (1.2 litres):
Press the 'ECO' button.
• Long flush (2.2 litres):
Press the 'NORMAL' but-
ton.
• You have the option of a short or a long
flush:
• Short flush (1.2 litres): Press the but-
ton once.
• Long flush (2.8 litres): Press the but-
ton twice.Press the button once for one
flush (5 litres).
WCS
• Pump the toilet empty by
pressing the button with the
pump symbol and holding
this in.
• Carry out a cycle without water.
ENGLISH
WCL
11
110123.02

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wc24s2Wc110sWc220sWc12l2Wc24l2Wc110l ... Afficher tout

Table des Matières