Commissioning - REMEHA iBase RF Guide D'utilisation

5 Commissioning

The Base station and the iSense RF are usually automatically connected to each
other. The manufacturer ensures this is the case. However, if you replace either of these
components the connection must be re-established. This is done as follows:
1. Open the housing of the Base station.
2. Press the connection button on the Base station and hold for three seconds.
The green status LED now flashes once per second.
3. Activate the Connect option on the iSense RF (see the iSense RF user guide).
The green LED on the Base station now flashes once every 4 seconds.
4. Check the iSenseRF to see if a connection has been established; repeat
the procedure if not.
5. Close the housing again.
The Base station and the iSense RF are now connected with each other again.
EN
29