Technical Data - Redstone DWS3255DB1 Manuel D'instruction

and perform its intended function. Check for misalignment
or binding of moving parts, breakage of parts, and any
other condition that may affect the tool's operation. A
guard or other part that is damaged should be properly
repaired or replaced at a qualified service centre.
7. Do not abuse the cord. Never use the cord to carry
the tools or pull the plug from the outlet. Keep cord
away from heat, oil, sharp edges or moving parts.
Replace damaged cords immediately. Damaged cords
increase the risk of electric shock.
8. Always make sure that your extension cord is in good
condition. When using an extension cord be sure to use
one that is heavy enough to carry the current that your
tool will draw. An undersized cord will cause a drop in
line voltage, resulting in loss of power and overheating.
9. Do not use the tool while tired or under the influence
of drugs, alcohol or any medication. Following this rule will
reduce the risk of electric shock, fire or serious personal injury.
10. Save these instructions. Refer to them frequently
and use them to instruct others who may use this tool.
If someone borrows this tool, make sure they have
these instructions also.
11. The operator is adequately trained in the use
adjustment and operation and operation of the machine.
12. Provide for adequate room lighting at your workplace
or for adequate lighting of the immediate work area.
13. Keep the work area well ventilated. If possible open
some windows and put an exhaust fan in one of them to
move air from inside to outside.
WARNING: the operation of any sander can result in foreign
objects being thrown into your eyes, which can result in
severe eye damage. Before beginning power tool operation,
always wear safety goggles or safety glasses with side
shield and a full face shield when needed.
Warning: If any parts are missing, do not operate your
sander until the missing parts are replaced. Failure to follow
this rule could result in serious personal injury.
Caution: Do not let familiarity with your sander make you
careless. Remember that a careless fraction of a second is
sufficient to cause severe injury.
6
Double insulation:
The tool is double insulated. This means that all the external
metal parts are electrically insulated from the mains power
supply. This is done by placing insulation barriers between
the electrical and mechanical components making it
unnecessary for the tool to be earthed.
Important note
Be sure the supply is the same as the voltage given on the
rating plate. The tool is fitted with a two-core cable and plug.
Remove the mains plug from socket before carrying out any
adjustment or servicing.
SYMBOLS
Always read the instructions
Always wear safety goggles
Always wear ear protection
Always wear a dust mask
Know your Dry Wall Sander
1. On/Off switch
2. Speed Regulator
3. Lock for telescopic length extension
4. Telescopic length extension
5. Dust extraction holder
6. Dust extraction hose
7. Sanding/grinding disk
8
. Power cable

TECHNICAL DATA

Volts: 230V~50Hz
Power input: 600W
Double insulation:
Weight: 4.80kg
Abrasive paper size O212mm
Oscillation rate: 1000-2000min-1
Sound and Vibration
Sound and vibration values were measured in accordance
with EN 60745
pA Sound pressure level
L
pA Uncertainty
K
WA Sound power level
L
WA Uncertainty
K
GB
GB
75.5 dB(A)
3 dB
86.5 dB(A)
3 dB