Roller Grill GES 23 Notice D'installation Et D'utilisation page 16

1
On/off pilot light
Orange pilot light
2
Thermostat /commutator
3
5. FUNCTIONING / MANIPULATION
a) Installation / assembly:
- Unpack carefully the device of its packaging.
- Place the waffle machine on a plane and heatproof surface.
- Never place the device near a wall or near a partition makes of combustible
materials even if it is very well isolated.
- A distance of minimum 10 cm with the partition or the wall is necessary.
- Remove the protective film from the stainless steel parts.
- Place the accessories.
b) First starting:
Before the first use, remove the anti-corrosion protection fat with a cleaner. Then, it is
necessary to grease plates with oil. Then proceed to the seasoning of the cast iron
plates. For this
- Grease the cast iron plates with oil.
- Plug in the waffle iron, turn the thermostat/commutator (n°3 on picture) to the
maximum setting :the orange pilot light (n°2 on picture) and the green pilot light (n°
1 on picture) switch on.
- Close the upper plate and let the waffle iron work during 30min
- After this seasoning, the first waffles will be very bad looking with black residue.
- To finish, grease slightly the plates. Your machine is ready to function.
First cleaning
Clean the device and all accessories before the first use. (see 6 Cleaning)
Connection of the device
- Check that the tension and the frequency of the electricity network suit to the val-
ues indicated on the descriptive plate.
- Check that neither the cord nor the plug are damaged
- Make sure that every control knob is positioned on 0.
- Unwind completely the electric power cable and connect it in a plug connected
with the earth.
- The device is connected.
4
Digital timer
Front drip tray
5
Back drip tray
6
16