ECOFOREST Kerala-1 Manuel D'installation Et Maintenance page 37


Keyboard's connection band and C.P.U.

Back side of keyboard.

Thermostat connection.

Power connection ~230/240V - 50Hz.

Thermostat.
IF YOU HAVE ANY DOUBT ABOUT THE CONNECTION, THE INSTALLATION PRACTICABILITY OR THE USE OF
SUCH DEVICES, CONTACT YOUR DISTRIBUTOR WHO WILL INFORM YOU.
A BAD USE OR SETTING OF THESE DEVICES MAY CAUSE A MALFUNCTION OR EARLY DEGRADATION OF THE
STOVE.
If the stove that you have is an Eco I Insert or Eco II, you must fix the safety thermostat to the panels of the
insert model. These panels have a hole, through which you must insert the thermostat (
and fix it to the socket with a nut (
model, showing the final result in the drawing 14.
For Ecoaire you must do the same process.
For the Kerala and the Córdoba models, the safety thermostat has been mounted on a support, to the right
of the fireplace.
Drawing 13
5. CLEANING AND MAINTENANCE.
To ensure the correct operation of your stove, the following cleaning and maintenance operations are
necessary at the indicated frequency. The stove must always be cold.
The deterioration of the stove parts by a lack of cleaning involves the loss of the two-year warranty offered
by ECOFOREST (see warranty section).
5.1. Heat Exchanger.
Pull the drawers of the rake-this shall be done while the glass door closed in order to reach the ash inside the
stove. This shall be done every day when the stove is cold.
ASSEMBLING OF THE SAFETY THERMOSTAT IN INSERT MODELS.

) and finally you screw the stopper (  ). The stove used in drawings is an EcoII
DAILY CLEANING WHEN THE STOVE IS COLD.
36
Drawing 12

) according to drawing 13,
Drawing 14