JVC KD-R975BTS Manuel D'instructions page 20

BLUETOOTH®
To
While talking on the first incoming call...
Answer another incoming
call and hold the current
call
Reject another incoming
call
While having two active calls...
End current call and
activate held call
Swap between the
current call and held call
Adjust the phone volume
[00] to [35] (Default: [15])
Switch between hands-free
and private talk modes
Improve the voice quality
While talking on the phone....
1
Press and hold .
Turn the volume knob to select an item (see the following table), then press
2
the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
16
On the faceplate On the remote control
( Not available )
Press or the volume
knob.
( Not available )
Press and hold or
the volume knob.
Press and hold
Press and hold or
the volume knob.
( Not available )
Press .
Turn the volume knob ( Not available )
during a call.
• This adjustment will not
affect the volume of the
other sources.
( Not available )
Press during a call.
• Operations may vary
according to the
connected Bluetooth
device.
.
MIC LEVEL
–10 — +10 (–4): The sensitivity of the microphone increases
as the number increased.
NOISE RDCT –5 — +5 (0): Adjust the noise reduction level until the least
noise is being heard during a phone conversation.
ECHO CANCEL –5 — +5 (0): Adjust the echo cancellation delay time until the
least echo is being heard during a phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
. 2
Turn the volume knob to select an item (see the following
table), then press the knob.
3 2
Repeat step
activated.
To return to the previous setting item, press
SETTINGS
AUTO ANSWER 01 SEC — 30 SEC: The unit answers incoming call
automatically in the selected time (in seconds). ;
OFF: Cancels.
RING COLOR (For KD-R975BTS / KD-R970BTS / KD-RD97BT /
KD-R97MBS)
COLOR 01 — COLOR 49 (COLOR 08): Selects the
notification light color for the buttons when there is an
incoming call and during a call. ; OFF : Cancels.
RING ILLUMI (For KD-R875BTS / KD-R870BT / KD-R770BT /
KD-RD87BT)
BLINK 1 — BLINK 5 (BLINK 2): Selects the notification
blinking pattern for the buttons when there is an incoming
call. ; OFF : Cancels.
until the desired item is selected or
Default: XX
.
Default: XX