Maintenance; General Maintenance - Ryobi RY40807 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 If the unit comes in contact with any type of obstruction
or debris during use, stop the snow blower, remove the
battery pack, remove the obstruction, and inspect the
unit carefully for damage before proceeding.
NOTE: If necessary, remove the cleaning tool from the
storage area and use it to remove any obstructions.
WARNING:
Never reach into the discharge chute or place any body
part in front of the snow blower when the unit is operat-
ing or when the battery pack is installed. Always ensure
all moving parts have stopped and the battery pack has
been removed before clearing any obstructions. Failure
to follow these instructions can result in serious personal
injury.
WARNING:
Before performing any maintenance, make sure the snow
blower battery is removed to avoid accidental starting
and possible serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
When servicing, use only authorized replacement parts.
Use of any other parts can create a hazard or cause
product damage.
WARNING:
Never use water or any liquids to clean or rinse off
your product and do not expose the product to rain.
Store indoors in a dry area. Corrosive liquids, water, and
chemicals can enter the product's electronic components
and/or battery compartment and damage electronic com-
ponents and/or the battery pack, which can result in a
short circuit, increased risk of fire, and serious personal
injury. Remove any buildup of dirt and debris by wiping
the product clean with a dry cloth occasionally.
OPERATION
 Take notice of the direction of the wind before beginning.
When possible, discharge snow in the same direction as
the wind to prevent snow from being thrown back into
your face.
 Some parts of the snow blower can freeze under extreme
weather conditions. Do not attempt to operate the unit
with frozen parts.
 When finished, allow the motor to run for an additional
few minutes, then turn the chute rotation lever back and
forth several times to remove any remaining snow from
the chute.
NOTE: If necessary, remove the cleaning tool from the
storage area and use it to remove any remaining snow
from the chute.

MAINTENANCE

NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which can result in serious personal injury.
 Maintain or replace safety and instruction labels, as
necessary.
11 — English

Publicité

Table des Matières
loading

Table des Matières