Transport; Storage; Possible Faults - ATIKA BH 700 Notice Originale

Transport

Pull the mains plug prior to transport.
The drum can be damaged during transport, e.g. on
hard ground, even when the motor is switched off.
Therefore carry the device.

Storage

Pull out main plug.
Before each fault clearance
− switch off device
− wait until the drum is stationary
− pull out main plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Device doesn't start
The device operates with
interruptions
Unusual sounds
Unusual vibrations
Unsatisfactory result

Possible faults

Possible cause
no power
Extension cable defect
Main plug, motor or switch defect
Protective motor switch has tripped
Extension cable defect
Internal fault.
ON/OFF button defective.
Drum is blocked
Loose screws, nuts or other fasteners
Cutting blade damaged or dull
Dull blades
Store unused equipment in a dry, locked place out of the
reach of children.
In case of extended storage (e.g. during winter) ensure that
the device is protected against frost and corrosion.
Before extended storage, please observe the following to
increase the service life of the device and to ensure smooth
operation:
− thoroughly clean the device
− Treat metal parts after each use against corrosion using
an environmentally friendly biologically degradable spray
oil.
Never use any grease!
Remedy
Check power supply, power socket and fuse
protection
Check extension cable, exchange defect cable
immediately
Have main plug, motor or switch checked by an
approved electrician or replaced by original
spare parts
1. Drum blocked
Allow the motor to cool down approx. 15
minutes before continuing to work
Check extension cable, exchange defect cable
immediately
Please contact the after sales service.
Please contact the after sales service.
Remove the blockage
Tighten all parts; contact customer service if the
noises continue to occur.
Please contact the after sales service.
Please contact the after sales service.
remove the blockage
13