Identification; Product Description And Type Designation; Product Markings - Videorec Verso Hi-PoE IPM Manuel D'instructions

Caisson en polycarbonate avec technologie ipm pour caméras ip
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
• Any device which could be installed inside the
product must comply with the current safety
standards.
• If the installation is NEMA TYPE 4X, the installer
must replace the cable glands of the product with
NEMA TYPE 4X cable glands.
• For all connections, use cables that are able to
withstand temperatures of at least 75°C (167°F).
• The product is designed to house only cameras
that are properly certified (7W max).
• A disconnecting device, readily and easily
accessible, must be incorporated in the electrical
system of the building for rapid intervention.
• Installation category (also called Overvoltage
Category) specifies the level of mains voltage
surges that the equipment will be subjected to.
The category depends upon the location of the
equipment, and on any external surge protection
provided. Equipment in an industrial environment,
directly connected to major feeders/short branch
circuits, is subjected to Installation Category III. If
this is the case, a reduction to Installation Category
II is required. This can be achieved by use of an
insulating transformer with an earthed screen
between primary and secondary, or by fitting
listed Surge Protective Devices (SPDs) from live
to neutral and from neutral to earth. Listed SPDs
shall be designed for repeated limiting of transient
voltage surges, suitable rated for operating voltage
and designated as follows: Type 2 (Permanently
connected SPDs intended for installation on the
load side of the service equipment overcurrent
device); Nominal Discharge Current (In) 20kA min.
For example: FERRAZ SHAWMUT, STT2240SPG-
CN, STT2BL240SPG-CN rated 120Vac/240Vac,
(In=20kA). Maximum distance between installation
and reduction is 5m.
• To connect the power supply line use the
appropriate junction-box (UPTJBUL). For further
information, refer to the product use and
installation manual.
• Use Listed copper tube crimping lugs for the
connection of the network conductors to the
terminals. The copper tube crimping lugs must
be suitable for the type of installation (from -20°C
(-4°F) a +80°C (+176°F) min., V-0). Copper tube
crimping lugs examples: RP, BP o YP (Cembre).
• Power supply to the product must be exclusively
provided by the PoE cable (Power over Ethernet).
4

4 Identification

4.1 Product description and type
designation
The VERSO Hi-PoE IPM housing exploits in an optimal
way the POE and Hi-POE technology, using the power
supplied by the Ethernet cable as the sole source of
power for all the devices connected, thus ensuring
the maximum efficiency and flexibility of the
network system as well as user-friendly installation
and low costs.
The innovative IPM (Intelligent Power Management)
system enables extremely quick and easy installation
with the use of a single Ethernet connecting cable.
The Hi-POE IPM system automatically detects all
the options, like heating, fan and illuminator and
then autonomously balances the power to ensure
suitable distribution of the same to the connected
devices. This guarantees the optimal operation of the
IP camera between -30°C (-22°F) and +60°C (140°F),
with heat regulation and cold start (activation at low
temperature).
The analog system, with previously installed camera
housings, can be retrofitted on IPM system simply
by changing the slide and the internal electronics.
This enables the digital conversion, speeding up
the installation and thereby minimizing costs and
environmental impact.

4.2 Product markings

See the label attached to the product.
MNVCHPVHPOE_1511_EN

Publicité

Table des Matières
loading

Table des Matières