Preliminary Operations - Dual CS 600 HiFi Notice D'emploi

1. Cover
2. Hinge
3. Tone arme counter weight
4. Scale for setting tone arm tracking force
5. Lift lever
6. Tone arm support with tone arm lock
7. Head shell locking nut
8. Securing screw for tone arm set down
9. Antiskating setting
10. Speed selector – ON / OFF
11. Screw for tone arm height adjustment
12. Audio Cinch plugs connection
13. Ground connection
14. Connection socket for mains adapter 12 V/DC

Preliminary operations

Unpack the unit and all accessories. Please keep the packaging
for future use when transporting the device.
− Fit the platter and depress the locking mechanism in its
centre until it engages in the groove of the platter spindle
(Fig. 1). Place the platter mat in position.
− Insert the hinges 2 in the appropriate recesses (Fig. 2)
− Slide the cover 1 parallel to the position of the hinges 2
(opening angle approximately 60°) until it locks in position.
In this position, the cover can be removed at any time.
Supply of the mains set
The delivered mains set (Fig. 14) will be connected to the so-
cket 14. The mains set, corresponding to the voltage indication
on the nameplate, has to be plugged into a power supply plug
either with 230 V / 50 Hz or 115 V / 60 Hz on the primary side.
connection to amplifier or receiver
– Connect the audio cables (Fig. 12) to the phono-mag-
netic-inputs of the amplifier or receiver 12 (red or black
RCA-type plug = right channel, white RCA-type plug = left
channel).
e n g L i S h
– Connect one side of the earth wire (Fig. 13) on the ground
socket on the device 13 and the other end to the amplifier..
Balancing the tonearm and setting the tracking and
antiskating force – for example cartridge oM 10
1. Remove the needle protector
2. Set tracking force 4 to 0 and switch off the antiskating
device 9.
3. Turn the counterbalance 3 on the tonearm (Fig. 3). Unlock
the tonearm and move it over the tonearm rest. Move the lift
lever 5 to the rear. Hold the tonearm whilst doing so.
4. Balance the tonearm precisely by turning the counterbalan-
ce. The tonearm is balanced precisely when it pivots freely.
5. Set the required tracking force for the cartridge by turning
the dial 4. The tracking force for cartridges OM 10 = 15 mN
= dial position 1.5.
Set the appropriate value of the antiskating device 9 on the
basis of the following table:
Tracking force
Tracking force scale 4
1.25 = 12.5 mN
OM 10 -> 1,5 = 15 mN
2.5 = 25 mN
height adjustment of tone arm
The entire tone arm assembly can be adjusted in height.
By loosening the set screw 11 you can move the tone arm in
height. Then tighten the set screw 11 again.
7
Antiskating setting 9
1 = 10 mN
2 = 20 mN
3 = 30 mN
1,25
1.25
1.52
2,25
2.52
3,25