Cleaning Grease Filters Manually; Troubleshooting - Junker JD66LF60 Manuel D'utilisation Et Notice D'installation

Select a temperature of no more than 70 °C.
Allow the grease filters to drain.
4.
7.6 Cleaning grease filters manually
The grease filters filter the grease from the cooking va-
pour. Regularly cleaned grease filters guarantee a high
level of grease removal.
WARNING ‒ Risk of fire!
Fatty deposits in the grease filters may catch fire.
Clean the grease filters regularly.
▶
Requirement: The grease filters have been removed.
→ "Removing the grease filter", Page 22
Observe the information regarding the cleaning
1.
agents.
→ "Cleaning products", Page 21
Soak the grease filter in hot soapy water.
2.
Use special grease solvent for stubborn dirt. You
can obtain grease solvents from after-sales service
or the online shop.
Use a brush to clean the grease filters.
3.
Rinse the grease filters thoroughly.
4.
Allow the grease filters to drain.
5.
7.7 Fitting the grease filters
1. ATTENTION!
Falling grease filters may damage the hob below.
Grip below the grease filter with one hand.
▶
Note: Note the correct position of the grease filter.
Insert the grease filter.
8 Troubleshooting
You can rectify minor faults on your appliance yourself. Read the troubleshooting information before contacting after-
sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
8.1 Malfunctions
Fault
The appliance is not
working.
The LED lighting
does not work.
The button illumina-
tion does not work.
Cause and troubleshooting
The mains plug of the power cord is not plugged in.
The circuit breaker is faulty.
There has been a power cut.
Different causes are possible.
Defective LED lights may be replaced by the manufacturer, their customer service or a
▶
qualified technician (electrician) only.
Call the after-sales service.
▶
→ "Customer Service", Page 24
The control unit is faulty.
Call the after-sales service.
▶
→ "Customer Service", Page 24
The lock on the grease filter clicks into place.
2.
If the grease filter has been inserted incorrectly,
3.
carefully push the lock forwards, remove the grease
filter and insert it correctly.
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced by trained specialist staff.
Troubleshooting en
23