Transmitter And Receiver Binding - Horizon Hobby Blade Nano CP X Manuel D'utilisation

Transmitter and Receiver Binding

If you purchased an RTF model, the transmitter is bound to the model at the factory.
To bind or re-bind your Nano CP X to your chosen transmitter, please follow the directions below:
Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally Unique
Identifi er) code of a single specifi c transmitter. You need to 'bind' your chosen Spektrum
ogy equipped aircraft transmitter to the receiver for proper operation.
NOTICE: Use the Non-Computer Radio binding instructions if you are using a DX4e or DX5e transmitter
with the Nano CP X BNF.
Binding Procedure for Computer Radios:
1. Disconnect the fl ight battery from the helicopter.
2. Power off the transmitter and move all switches to the 0 position.
3. Connect the fl ight battery to the helicopter. The 3-in-1 Control unit LED fl ashes after 5 seconds.
4. Push the bind switch/button while powering on the transmitter.
5. After 2–3 seconds, release the bind switch/button.
6. Move the rudder control stick to full right. Continue to hold the rudder control stick to full right until the
blue LED on the 3-in-1 control unit is solid.
7. Release the rudder control stick.
8. Disconnect the fl ight battery and power the transmitter off.
NOTICE: The throttle will not arm if the transmitter's throttle control is not put at the lowest position and the stunt
mode switch is not in the 0 position.
If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other
instructions. If needed, contact the appropriate Horizon Product Support offi ce.
For a list of compatible DSM2/DSMX transmitters, please visit www.bindnfl y.com.
Binding Procedure for Non-Computer Radio (DX4e, DX5e)
1. Disconnect the fl ight battery from the helicopter.
2. Power off the transmitter and move all switches to the 0 position.
3. Connect the fl ight battery to the helicopter. The 3-in-1 Control unit LED fl ashes after 5 seconds.
4. Push the trainer switch or button while powering on the transmitter.
5. Move the rudder control stick to full left after the transmitter LED lights fl ash twice.
6. Release the trainer switch/button. Continue to hold the rudder control stick to full left until the blue LED
on the 3-in-1 control unit is solid.
7. Release the rudder control stick.
8. Push the trainer switch/button. The blue LED on the 3-in-1 control unit fl ashes to confi rm the helicopter
is in non-computer mode.
9. Disconnect the fl ight battery and power the transmitter off.
NOTICE: If the swashplate moves up and down when the trainer switch is moved, the helicopter is in computer
transmitter mode; repeat binding procedure.
7
™ ® ®
DSM2 / DSMX technol-
®
EN