Putting Into Operation - aslotel Premier E005500 Mode D'emploi

Operating the appliance for the
first time
FIG. 1
Before using the kettle for the first time, fill it
up to the maximum level (1.0 litres) and boil
at least two lots of water. Rinse the kettle out
with cold water each time between boiling up
these two lots of water.
Method:
Adjust the required length of cable on the
power base "g" . Wind any cable not requi-
red onto the cable winder. Guide the cable
through one of the three recesses (1).
Connect the power base "g" according
to instructions (observe the safety
instructions) (1).
Put the appliance into operation (see

"Putting into operation").

Putting into operation
FIG. 2 – 8
Filling with water
Open the safety locking lid "a" with the
lid opener "b" and fill the kettle while the
lid is open (2; 3).
Check the filling level on the water level
gauge "e" . Note the maximum filling
level (4)!
Note
If the kettle was accidentally started
empty, the safety cutout will automati-
cally switch it off. In this case you should
remove the kettle from the power base
and allow it to cool down for a few minu-
tes. Make sure that the kettle has been fil-
led with an adequate amount of water
before using it again.
Switching on the kettle
Close the lid. The safety locking lid must
lock into place (5). Connect the power
base to the mains and position the kettle
on the power base (6).
Note
If the lid is not properly closed, the kett-
le will not shut off automatically.
Switch on the kettle at the ON/OFF
switch "f" - the red heating control lamp
"c" lights up (7).
Note
The ON/OFF switch only operates when
the kettle is located on the power base.
Warning! Risk of scalding!
Never open or remove the lid during
operation.
Switching off the kettle
The kettle switches off automatically
when the water boils - the red heating
control lamp "c" goes off (8). However,
you can also switch the kettle off using
the ON/OFF switch "f" at all times.
Note
The kettle also switches off automati-
cally when it is removed from the
power base.
Switching the kettle back on again
The kettle can be switched back on again
after being allowed to cool down for
approx. 30 seconds.
Pouring out the water
Remove the kettle from the power base
and pour out the hot water.
Note
As a result of its functioning, some
water can condense out of the outlet
openings in the base of the kettle and
run out over the edge of the power
base. This is normal and is perfectly
harmless.
If the kettle is returned to the power
base, any water left in it will only heat up
if the kettle is switched on again.
13