Cleaning The Sensor; Troubleshooting; Technical Data; Disposal - ProfiCare PC-LR 3076 Mode D'emploi

Cleaning the Sensor

NOTE:
• Only clean the sensor after the filter element has been
cleaned or replaced.
• If the sensor is the only component that is cleaned
it will become dirty very quickly. This may cause the
displayed air quality to be no longer accurate. It is
therefore necessary to always clean both the filter
element and the sensor.
Problem
Appliance does not work.
The appliance is too loud.
Too little air flows out of the
outlet.
The coloured ring is permanently
red.
It is not possible to press a
button.
The appliance does not respond
to the remote control.

Technical Data

Model:..................................................................PC-LR 3076
Power supply:..................................220 - 240 V~, 50 Hz 60 Hz
Power consumption: ....................... 50 Hz: 45 W; 60 Hz: 55 W
Standby performance: ...................................................0.3 W
Protection class: ...................................................................
Net weight: ..................................................... approx. 4.45 kg
The right to make technical and design modifications in
the course of continuous product development remains
reserved.
This appliance has been tested according to all relevant
current CE guidelines, such as electromagnetic compatibility
and low voltage directives, and is manufactured according
to the latest safety regulations.

Disposal

Battery Disposal

As a consumer you are obliged by law to return
old batteries / accumulators.
Remove the battery from the remote control
before disposing of the appliance.
42
PC-LR3076_IM
1. Use a thin, flat tool (e.g. a small flat-head screwdriver) to
2. Use a cotton swab without addi-
3. Close the cover. It must audibly

Troubleshooting

Cause
No power supply.
Electronic defect.
High air humidity.
Soiled filter element.
Soiled filter element.
Dirty sensor.
Soiled filter element.
Child lock is enabled.
The battery of the remote con-
trol is empty.
The remote control is defective. Please contact your dealer or the service department.
Return the battery to a collection facility for the collection of
old batteries or hazardous waste. Contact your local author-
ity for more information.

Meaning of the "Dustbin" Symbol

This helps avoid the potential effects of incorrect disposal
on the environment and human health.
This will contribute to the recycling and other forms of
re-utilisation of electrical and electronic equipment.
Information concerning where the equipment can be dis-
posed of can be obtained from your local authority.
lift the cover located on the right side of the appliance.
Open it by flipping it to the right.
tives to clean the sensor and all
other surfaces of the appliance at
least every two months (see adja-
cent figure).
engage.
Solution
Examine the power supply connection.
Please contact your dealer or the service department.
Reduce air humidity by a dehumidifier.
Replace the filter element.
Replace the filter element.
Clean the sensor and the filter element. If necessary,
replace the filter element.
Switch off the child lock via the LOCK button on the
remote control.
Replace the battery.
Protect our environment: do not dispose of
electrical equipment in the domestic waste.
Please return any electrical equipment that
you will no longer use to the collection points
provided for their disposal.
28.11.19