Caution; Handling Batteries; Unpacking The Appliance; Overview Of The Components / Scope Of Delivery - ProfiCare PC-LR 3076 Mode D'emploi

CAUTION:

This appliance is not intended for immersion in water during
cleaning. Please refer to the instructions provided in the chapter,
"Cleaning / Maintenance".

Handling Batteries

WARNING:
• Do not expose batteries to excessive heat such as
sunlight, fire or similar. There is a risk of explosion!
• Batteries are not toys. Keep away from children.
• Do not open batteries by force.
• Avoid contact with metal objects (rings, nails, screws,
etc.). There is a risk of short circuit!
• A short circuit could cause the battery to heat up ex-
cessively or even to catch fire, resulting in injuries.
• For your own safety, cover the battery terminals with
adhesive tape during transport.
• In case of battery leakage, make sure not to rub the
liquid into your eyes or mucous membranes. In case
of contact, wash your hands and rinse your eyes with
clear water. Seek medical attention if any discomfort
persists.
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Batteries can leak and lose battery acid. If the remote
control is not used for a long period of time, remove
the batteries.

Unpacking the Appliance

1. Take the appliance out of its packaging.
2. Remove all the packaging material such as plastic foil,
filling material, cable ties and cardboard packaging.
3. The filter element is wrapped in foil for protection against
damage during transport. Before using the appliance for
the first time, remove the foil and proceed to the sections
"Cleaning / Maintenance" and  "Replacing the Filter
Element".
4. Check that all parts are supplied in the box.
5. In case of incomplete delivery or damage, do not operate
the appliance. Return it to your dealer immediately.
PC-LR3076_IM
Overview of the Components /
Scope of Delivery
1 Air outlet
2 button (sleep mode / power saving mode)
3 Indicator lamp "SLEEP"
4 Colour ring as indication of air quality
5 Indicator lamp "TEMP (° C)"
6 Indicator lamp "IONS"
7 button (time-delayed switch-off)
8 Display
9 button (on / off)
10 Indicator lamp "LOCK"
11 button (power level selection)
12 Recessed grip
13 Sensor cover
14 Cover / Air intake
15 Motor housing
Not illustrated

Remote Control

Remote Control
NOTE:
The button cell in the battery compartment of the remote
control has been secured with a foil for transport. This
will extend the durability of the battery. Before initial use
please remove this foil so that the remote control is ready
for operation.
The range of the remote control is limited.
When using the remote control, please ensure that there
are no obstacles placed between it and the sensor on the
appliance.

Changing the Battery of the Remote Control

If the range of the remote control is reduced during use,
please proceed as follows:
1. First open the battery compartment cover on the back of
the remote control.
2. Replace the button cell with a battery of the same type
(CR2025). Ensure correct polarity. Insert the battery and
ensure it is positioned between the two metal contacts.
3. Then close the battery lid.
39
28.11.19