SKYTRONIC HT-510 103.153 Mode D'emploi page 4

Note: It is always recommended to use high quality audio leads for the connections.
Controls and operation:
After switching the amplifier on, you can select the required audio source via the buttons AC-3/ VCD/ CD and
AUX (23-26). The names of these buttons are the same as those of the inputs on the rear panel. If you press
the button AUTO (3, the amplifier switches automatically over to the input signal.
The volume is set via the volume control (6). The high and low frequencies are set via the buttons + and –
(27 & 28). The balance between left and right is set via the buttons L and R (29). If you want to mute the
sound up to zero, press the MUTE button (2). You can switch the loudness on and off via the LOUD button.
This option ensures a better balance between the various tones.
Depending on the number of boxes that you have connected and your personal taste, you can select the
boxes you wish to use via the buttons 2CH / 3CH and 5CH (15). In all cases, if you have connected a
subwoofer, this will always be active.
The volume of the subwoofer channel, the two rear speakers and the centre speaker can be set via the +
and – buttons (11 – 14). To make use of the pre-programmed settings, you can press one of the DSP
buttons (10).
If you wish to use one (or two) microphone(s), connect them to the 6.35mm jack sockets (7 & 8) on the front
panel of the amplifier. Set the volume of the microphone via the button MIC. VOL (5). The high frequencies
(20), the low frequencies (21) and the echo (19) are controlled via the buttons + and -. Press SPEECH (4) to
change the tone of the voice. Set the delay to the required number of milliseconds 24 / 48 / 72 or 96. Press
the button OK (22) to determine if you want to hear the sound from the microphone or not
All information re the settings and selections is clearly displayed on (9). Press the MODE button (16) to
display the sound level on the VU-meters.
Layout:
Front panel
1. POWER
2. MUTE
3. AUTO
4. SPEECH
5. MIC. VOL
6. MASTER VOLUME
7. MIC 1
8. MIC 2
9. DISPLAY
10. DSP
11. SW. VOL
12. SL. VOL
13. CEN. VOL
14. SR. VOL
15. 2/3/5 CH
16. MODE
17. 24/48/72/96 ms
18. LOUD
19. ECHO
20. M. TRE
21. M. BASS
22. OK
23. AC-3
24. VCD
25. CD
On/Off switch
Temporary sound cut
Automatic search for the connected audio source
Tone control fro voice
Microphone volume
General volume
6.35 mm microphone jack (1)
6.35 mm microphone (2)
Displays all information
Selection among 8 pre-programmed DSP settings
(speaker settings, equalizer, etc.)
Individual volume control for the subwoofer
Individual volume control for left rear speaker
Individual volume control for centre speaker
Individual volume control for right rear speaker
Selection of the (connected) speakers
Selection among various display modes of the VU-meters
Microphone delay
Loudness on/off
Echo setting for the microphone
High frequency setting for the microphone sound
Low frequency setting for the microphone sound
Microphone sound on/off
Select audio source AC-3
Select audio source VCD
Select audio source CD