Safety Information; Caution; Range Of Applications - Schick Dental Profi Mode D'emploi

1. Safety information

1.1 Ascertain that your mains supply coincides with the data on the rating plate.
1.2 units are not suitable for the following applications:
- in areas where there is a risk of explosion
- for medical applications
- for working on moist materials
1.3 Ensure that all regulatory requirements are observed during use
- always wear protective glasses
- provide enough light at the working place
- use dust suction
1.4 Under no circumstances should the motorhandpiece be cleaned with compressed air.
1.5 Before putting the handpiece down, always insert a rotary instrument or the pin, supplied
with the unit, into chuck.

Caution!

- When using rotary instruments, do not exceed the maximum speeds laid down by
their manufacturer.
- When operation with left-hand rotation, the chuck may loosen when there is a high load.
- Repairs and other technical procedures must only be carried out by suitable qualified
personnel, authorized by SCHICK.
- SCHICK do not guarantee the
with the operating instructions.

2. Range of applications

The unit is designed for universal use in dental laboratories when trimming crowns and
bridges, respectively acrylic and light chrome cobalt dentures. With its speed range from
1.000 - 50.000 rpm (1.000 - 40.000 rpm foot control) the SCHICK
all dental materials.
The motorhandpiece is ergonomical, small shaped and runs smoothly, thus eliminating user-fatigue
and making it economical to use over long periods. The progressive processor controller constantly
monitors the unit for overloading. A second thermal fuse, which is independent of the
computer, provides further protection. Thus the
Conditions of environment:
- interior 5° - 40° C.
- up to 2,000 meter over sea level
Categorie of overvoltage: II
Grade of pollution:
WEEE-Reg.-Nr. DE 78620387
unit should it not have been used in accordance
2
unit allows to work
unit offers a maximum of safety.
3