Initial Start-Up; Switching On And Off - Schick Dental Profi Mode D'emploi

5.3 Initial start-up

Connect the network cable (6) to the power supply (5a). Connect the motorhandpiece to the
'motorhandpiece 1 'socket.
Plug the network adaptor into the power supply socket on the control unit.
To switch on the device, activate the operating component (knee pad, foot lever, etc.) once.
power supply
.

5.4. Switching on and off:

There is no main switch for the
it switches off automatically. By simply touching the control device (knee pad /foot pedal), the device is
switched on again.
Basically, first attach the handpiece before connecting the mains cable and switching the control
mechanism on.
5.5 Connection of the signal transmitter for automatic swichting on of a workplace suction device
In order to operate the workplace system together with a workplace suction system with automatic
function, the signal transmitter for the suction signal must be connected. This is, as shown in the
illustration, inserted in the suction signal jack on the control unit. At the opposite end, in the
appropriate connector socket on the workplace suction device.
.
control unit
When operation together with a KaVo SMARTair suction or a Zubler suction AP 501, the optional cable
art.no.: 9229 can be used as signal connection for controlling the suction.
signal for suction
motorhandpiece 1
control unit. If the hand piece is not used for more than 60 minutes,
signal transmitter for suction
7
serviceplug
suction with automatic function