Standard» Transmitter Button(S) / Receiver Relay(S) Association - Jay Electronique ORION Série Notice Technique D'installation Et D'utilisation

«Standar d» association of transmitter
5.3-
button(s) with receiver relay(s)
This procedure is used to :
• Automatically erase the previous settings in the receiver
• Store, in the receiver, the new identity code programmed on the transmitter
• Programm the receiver on the transmitter radio channel
• Perform a standard association of the transmitter buttons with the receiver
relays as follows :
Button n°1 of the transmitter allocated to the relay n°1 of the receiver,
Button n°2 of the transmitter allocated to the relay n°2 of the receiver,
Button n°3 of the transmitter allocated to the relay n°3 of the receiver,
IMPORTANT
This programming procedure erases all the button/relay associations,
interlock functions, relay operating modes of the previously programmed
relays and radio channel setting.
The receiver is equipped with 3 programming jumpers/microswitches
and and three LEDs with
JP3
user during programming procedures (
receiver is powered).
The «standard» association procedure uses jumpers (or microswitches) JP1 and
receiver jumper/microswitches..
JP3
1- Switch off industrial receiver (ORRA or ORRS), the receiver on DIN rail
(ORRD) can remain power supplied during all the procedure.
2- For the ORRS and ORRA, place jumpers
position (
JP2
and to the «ON» position.
JP3
V1 V2 V3
JP3
JP1
JP2
and
JP3
JP1
on ORRS receiver
324501F
revision02
not short-circuited ), for ORRD receiver, set microswitches
V1 V2 V3
jumpers
JP1
...etc
, and
V1 V2
is switched ON continuously when
V1
JP1
JP1 JP3
JP2
and
JP3
jumpers
on ORRA receiver
De
which give indication to the
V3
and JP3 in the short-circuit
JP1
JP2
JP3
JP4
and
JP1
on ORRD receiver
Gb Fr
,
JP1 JP2
JP1
OFF ON
V1 V3 V2
JP3
switches
- 65 -