Introduction; Network Module Connections; Network Module Installation - Komfovent Ping2 Manuel D'installation

Masquer les pouces Voir aussi pour Ping2:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33

INTRODUCTION

Network module "Ping2" is intended for connection of KOMFOVENT air handling units to the computer network
(Ethernet) or another network ("RS-485"). If "Ping2" module is not added by factory, it can be installed on each air
handling unit (AHU) with C3 or C4 controller. For this case user need to have installation kit:
1. Network module ("Ping2").
2. Additional connection cable (5 m.).
3. Installation Manual.

1. NETWORK MODULE CONNECTIONS

2. NETWORK MODULE INSTALLATION

1. Network module can be installed provided place under given following conditions:
● ambient temperature range 0°C ... 40°C;
● relative humidity limits 20% ... 80%;
● protection must be ensured from accidentally vertically falling water drops (IP X2).
Cable length between AHU and "Ping2" module can't exceed more then 50 m
with type 4x0.22 mm
2. After Network module is installed in provided place control panel needed to be disconnected from air handling unit:
UAB AMALVA we reserve the right to make changes without prior notice.
or not more 100 m with type 4x0.35 mm
2
GND
B
A
Picture 1a
2
Picture 1b
9

Publicité

Table des Matières
loading

Table des Matières