Ping2" Module Configuration; User Settings - Komfovent Ping2 Manuel D'installation

EN

4. "PING2" MODULE CONFIGURATION

Net module "Ping2" has internal web side therefore not needed any special software to configure and set parameters,
all setting may be done using standard internet browser. To modify setting and control of air handling unit the
connection with PC is needed.
CONNECTION
1. Plug one end of the network cable into the "Ping2" module and the other end to the computer.
2. Go to the properties of your network card and enter IP address, e.g. 192.168.0.200, and subnet mask
255.255.0.0.
3. Open the web browser on your computer and disable all proxy servers in the settings.
4. In the address bar of your web browser enter the IP address associated with the air handling unit; the default
IP address is 192.168.0.29.
Note: It is recommended to download the latest version of your web browser before use.
5. If the connection is successful, a window prompting to enter your user name and password appears:
Note: the user name is "user". The initial password is also "user"; after logging in, the user can later change the
password to any other of his/her choice (see user interface settings).
Note: In case you forget your IP address or password, you can restore it to default. See "Connection parameters
restore"

USER SETTINGS

12
UAB AMALVA we reserve the right to make changes without prior notice.
1
2
3
4
5
6
7
8