Flotec FP0S2000A Notice D'utilisation page 4

Operation
OPERATION
Risk of electric shock. Do not handle
a pump or pump motor with wet hands or when
standing on wet or damp surface, or in water.
1. Shaft seal depends on water for lubrication. Do
not operate pump unless it is submerged in
water as seal may be damaged if allowed to run
dry.
2. Motor is equipped with automatic reset thermal
protector. If temperature in motor should rise
unduly, switch will cut off all power before dam-
age can be done to motor. When motor has
cooled sufficiently, switch will reset automatically
and restart motor. If protector trips repeatedly,
pump should be removed and checked as to
cause of difficulty. Low voltage, long extension
cords, clogged impeller, very low head or lift, or
a plugged or frozen discharge pipe, etc., could
cause cycling.
For assistance, call Flotec Customer Service at
3. Pump will not remove all water. If the pump is
operating and suddenly no water comes out of
the discharge hose, shut off the unit immediately.
The water level is probably very low and the unit
has broken prime.
Risk of electric shock. Before
attempting to check why unit has stopped oper-
ating, disconnect power from unit.
NOTE: This pump has no serviceable parts.
1-800-365-6832
4