Intended Use; Operation; Safety; Initial Use - Sanitas SHK 18 Mode D'emploi

3. Intended use

IMPORtANt
This heating pad is only designed to warm up the human body.

4. Operation

4.1 safety

cAutION
The heating pad is fitted with a SAFETY SYSTEM. This sensor technology provides protection against
overheating across the entire surface of the heating pad with an automatic switch-off in the event of a
fault. If the SAFETY SYSTEM has switched off the heating pad, the temperature settings are no longer
illuminated when switched on. Please note that for safety reasons, the heating pad can no longer be
operated after a fault has occurred and must be sent to the specified service address.

4.2 Initial use

IMPORtANt
Ensure that the heating pad will not bunch up or become folded dur-
ing use.
• First, connect the controller to the heating pad by inserting the plug-in
coupling.
• Then plug the mains plug into the socket.

4.3 switching on

To switch the heating pad on, set the sliding switch for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings (4) are illuminated when switched on.

4.4 setting the temperature

Level 0: OFF
Level 1: minimum heat
Level 2: medium heat
Level 3: maximum heat
NOte
• The fastest way to warm up the heating pad is to initially set the highest temperature setting.
WARNING
If the heating pad is being used over several hours, we recommend
that you set the lowest temperature setting on the controller to avoid
overheating the heated body part, which may lead to burns to the skin.

4.5 Automatic switch-off

This heating pad is equipped with an automatic switch-off function. This turns off the heat sup-
ply approx. 90 minutes after the initial use of the heating pad. The temperature setting display
then starts to flash. So that the heating pad can be switched back on, the sliding switch for ON/
OFF and temperature settings (5) must first be set to setting "0" (OFF). After about 5 seconds
it is possible to switch it on again.
11
90
min
STOP