emerio TG-110281.1 Mode D'emploi page 4

- Before you go mounting or dismantle parts;
- Before cleaning or maintenance work;
- After use.
11. Only have the appliance repaired by a qualified service
centre.
Electricity and heat
1. Before use, check that the mains power supply voltage is
the same and the voltage is the same as the voltage
indicated on the appliance.
2. Always plug the appliance into an earthed plug socket.
3. Regularly check the power cord for damage.
4. Do not operate any appliance with a damaged cord or
plug or after the appliance malfunctions, or is dropped or
damaged
manufacturer or the nearest authorized service agent for
examination, repair or electrical or mechanical adjustment.
5. To remove the plug from the plug socket, pull the plug. Do
not pull the power cord.
6. Make sure the power cord does not come into contact
with hot surfaces or steam.
7. Always remove the plug from the plug socket before you
move the appliance.
8. The machine should not be operated by means of an
external timer-switch or by means of a separate system
with remote control.
9. If an extension cord is absolutely necessary, a 10-ampere
cord should be used. Cords rated for less amperage may
overheat. Care should be taken to arrange the cord so that
it cannot be pulled or tripped over.
10. To avoid a circuit overload, do not operate another high
voltage appliance on the same circuit.
11. To protect against electric shock do not immerse cord,
plugs, or housing in water or other liquid.
- 3 -
in any manner. Return appliance to
TG-110281.1