Instructions For Use - M Confort E700 Manuel De L'utilisateur

MCONFORT E700
V. INSTRUCTIONS FOR USE
1-. Remove the equipment from the packaging and place it on the floor.
2-. Check that all parts are present according to section III.
3-. Place the wheels in their seats. The wheels with brake are placed on the sides
of the front and those without brakes are placed in the back and in the center
front.
4-. Remove the tank and add water according to the following indications:
5-.Connect the equipment to an outlet with the appropriate voltage. When
connected, it will beep and the equipment will be in Stand-by mode.
Notes:
- To avoid a short circuit, do not disconnect the equipment with wet hands.
- Make sure that the plug is properly connected in its housing.
14
a. Observe the water level at the front to avoid overfilling.
b. The water level in the tank must be maintained between the MAX and
MIN marks.
c. It is possible that, after a few hours of use, the water in the tank
acquires a certain odor. If so, it is recommended to change the water and
clean the reservoir more frequently.
d. Water shortage alarm: When the water level is below the MIN, an
alarm will sound and the corresponding indicator will appear, which will
go off when the tank is refilled and the cooling function will be
operational again.